- This topic has 1 reply, 2 voices, and was last updated 12 years, 1 month ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
We do not use a duct blaster, rather a blower door with pressure pan. How do I enter the measured leakage into the software as our measurements are at cfm50? Is there a conversion?
Thanks.
Apologies for the delayed response. We had a temporary malfunction in our notification system.
My understanding is that pressure pans are only suitable as a diagnostic tool and their readings cannot be used to drive a model of duct leakage. You will have to use the generic leakage description selections in the Leakage control.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.